I just can't seem to figure this out. I put in a new wiring harness for the tilt trim and had to splice in all the wires for it.The tilt trim works now,but when I started the motor it wouldn't turn off. I don't know if it put the wires back the same way on the wire bar. I think I did. I took...
Has anyone ever converted there 3 wire tilt and trim to 2 wire. I'm having problems with my wiring and found a company that sells a conversion kit. I have a 1990 evinrude 70hp model # E70TLESB The part is coming up obsolete from all the companys that sell parts. The harness is sparking from...
Has anyone ever converted there 3 wire tilt and trim to 2 wire. I'm having problems with my wiring and found a company that sells a conversion kit. I have a 1990 evinrude 70hp model # E70TLESB The part is coming up obsolete from all the companys that sell parts. The harness is sparking from...
Re: starcraft 1992 cc mr170
Re: starcraft 1992 cc mr170
.
Finally gaining some ground on my project. I have the steering and controls hooked up, The console is all mounted. Now the fun begins on the wiring. Once thats done I'll be able to check out the motor and see if I can get her fired...
Re: starcraft 1992 cc mr170
Re: starcraft 1992 cc mr170
I'm getting the hang of this vinyl thing. The more I do it the better I'm getting at it. Just can't wait to finish her up and use her. Console is going in tomorrow morning. Then the wiring mess begins.
Re: starcraft 1992 cc mr170 rebuild
Ok so I put in a 1 1/2 in plastic pipe to run wires through and had to change the end piece because I couldn't get the control cables through the bend. I put it to 2'' and they went through like butter lol Vinyl is almost installed and have to get...
I have to buy a power pack and was wondering if anyone had a preference to what they had good experiences with. The price isn't really that much in difference and I'm stuck on what I should buy. It for a 1990 Evinrude 70hp Model #E70TLESB. The motor has no spark and I think that I'll just...
Just trying to finish up my project and was wondering what everyone uses for flooring in there aluminum boats. I was thinking about carpet but then was looking at some of the vinyl flooring. Boat still has some ways to go before finishing and have the winter to think about it.Would love to hear...
I'm getting ready to start painting my 17 Starcraft C.C I took off all the paint and now I want to gulvit the outside. I know everyone says to put it on the inside,I'm going to do that also but just want the extra protection. Should I vinegar wash the hull before I pull down the Gluvit. Can I...
Hi, I just picked up a 1990 Evinrude E70TLESB motor. The compression is 110 in all 3 cylinders. Carbs look good.It run great when the guy took it off his boat do to rotten transom.When he went to start it on a stand it wouldn't start.No spark to all the plugs.Does anyone have any idea what could...
