With a 225 OMC stern drive. I want to install a four stroke kicker bracket and mount a four stroke Yamaha 9.9 kicker. Just got this boat and not to familiar with OMC and installing my fishfinder today I drilled a hole on the top of the transom for cables and was surprised the transom was maybe...
I inherited a 22’ Slickcraft 225 chev OMC so sold the Glassply. OMC runs strong but would like to get a donor Which will be a topic for another day. Motor is strong but would like to transition it to mercruiser if I can find a similar Mercruiser motor and key to prop tip setup.
I got fed up with it and dropped it off at the shop today. I did buy a new stainless relief valve and if you can believe it only 1/2 of the first oring to go in was left on it. So ya 1/2 the smallest ring is rolling around in there somewhere. Brand new and the oring crapped out.
Ok have a line on a couple complete 4.3 setups. And I do look to find answers but again some differing answers on the motor mount questions. My boat is a Glassply so obviously 470 to 4.3 previous adapts have been done. Is there a measurement I can use to be sure my mounts are wide enough for the...
I have the black cap trim pump on my 125 hp 1996 merc. Last fall I loosened relief valve to lower it. When I hit the pump this spring the plug came out sprayed some oil out. I’ve been trying to prime it and have had to raise and lower it by hand. Do I need to continue filling and raising and...
One more rookie question subbing an entire 4.3 setup for the 470 would require what engine support adapts? I’ve been getting some mixed answers, and boat is 19.5 and a heavy hull. I also have a line on a 165 Mercruiser. What about it for engine support adapts?
