Recent content by paulswagelock

  1. P

    Time for a new battery charger

    Plug in chargers (wet mount) can’t be used on a cruiser that has 12v load while sitting at the dock (Like a fridge). Almost all wet mount chargers time out if the battery does not reach full charge after 15 hrs or so and won’t start charging again until power is reset. Your hardwired charger...
  2. P

    2001 Maxum 2400 sc for 13k v 1995 FourWinns 238 vista

    I know this market is still crazy, but those both sound high, regardless of condition. As mentioned, those are both ripe to have transom and stringer issues, so check closely. In my area a new interior will run $6-8k.
  3. P

    Mercruiser 8.2 w/Cats & Closed Cooling Question

    If you don’t mind saying, what did this maintenance bill come to?
  4. P

    Off-Season Float Battery Charging, 2 Batteries

    Agree. Better plan is off and 2 chargers. If connecting to both, you need a bigger charger.
  5. P

    Oil Analysis for high-hour 4.5L 250 HP

    I did a similar evaluation years ago, so the formulations have changed. The Merc branded oils all sheared to a 30 or 20 wt but the wear metals were still ok. Rotella 15w40 held grade and the wear metals were good, even a touch better but it was only 1 analysis. Valvoline 15w40 held grade and...
  6. P

    Oil Analysis for high-hour 4.5L 250 HP

    I have seen several analysis now on the Merc oil where it sheers to a 30 wt. still functioned well, but it does not hold its grade well.
  7. P

    I freeze my block so you don't have to!

    Cool experiment. What sensors and software are you using?
  8. P

    Battery charger size needed

    I would do a 12a or 20a. Smaller than that brings no advantage.
  9. P

    4.5 mpi winterization tstat or muff fill?

    It is best to fill via the correct hoses / inlets on the motor over sucking it in through muffs.
  10. P

    Professional Mariner protech 4 series battery charger

    It should be wired directly to each battery. It sounds like it might be wired to the battery switch instead. Go find out and let us know.
  11. P

    Impeller location BRAVO 3 ?

    Bravo 3 has a belt driven water pump on the lower left side looking at the motor from the front.
  12. P

    Leaking toons

    Without much detail, looks like someone painted the toons with copper based antifouling paint and electrolysis is getting the best of them.
  13. P

    496mag no start issue.

    Let us know the results.
  14. P

    forward drive/bravo 4

    Friend has the Volvo version. Likes it, does ok for a casual wake, and is better than a fixed prop for regular cruising. Loading on a trailer and his lift both required new skills and cautions because of the increase draft.
Top