New to me little boat.. Seems sound, needs TLC for sure.
I would like any information on the model or specifics to this brand/model. Things to look out for?
Also, even if its likely not affordable, is there a vendor that makes a new canvas (?) top??
Any info appreciated!
I have a 59' 3hp (gale). What type of plug should it have? What brand is recommended? I got it started with likely the wrong plug, but it runs!!... Any advice appreciated!
I moved the piston to the bottom of the stroke with a grease gun and fitting, but now with the port exposed thats all I can do with grease. Its still stuck, and wondering what works with these engines? I cant seem to loosen up the rod bolts, they are slotted screws and dont budge-seems like...
Thanks all for the assistance! Im just starting, and reading the board here has generated some questions...
Is this an air cooled, or water pump?
Mixture?
Sparkplug #?
Oil or grease in the gears?
72 25 hp Evinrude, bought a thermostat and impeller kit. Found the thermostat location fine, not too sure about the impeller situation..? What will I run into? Any tricks to make it succussfull?:confused:
Something caused the points to get so hot the spring lost its ability to close the...
72 Evinrude 25hp. Have a puller on, cranking down pretty hard and have been tapping... Not budging..Im new to outboards and IM not sure how hard to crank, and how hard to "tap"...
Any advice appreciated!
Greeting all, I have a 1972 25 HP Evinrude, I relocated the ignition switch and might have wired something incorrectly, I was very careful to move one wire at a time, but some how when I turn it off it wont quit anymore.
I would appreciate any insights about this issue..
The ignition switch...
