Recent content by doh13

  1. D

    VP 5.7 Gxi hits rev limiter @ 4300

    Yea seems like it's hitting a rev limiter for sure, the tachometer seems to be the likely culprit . I will have to verify with an rpm reader or look into the vp adapter when I get the chance thanks for the info.
  2. D

    VP 5.7 Gxi hits rev limiter @ 4300

    There was no alarms it revs to approx 4200 in netural then hits a rev limiter and the same under load in gear , your right that it could be many things , I tested the fuel pump pressure and it was holding at 50 psi at high rpm . I need to get a rpm tester to see if the gauge is off , If it's...
  3. D

    Adding a water pressure gauge to 1987 70ETLH

    Maybe I will install a temp gauge instead or just leave well enough alone, Thank you for the info sir!
  4. D

    Adding a water pressure gauge to 1987 70ETLH

    No worries about other boats they are usually few and far between in my area, I might run a few rock ledges over whilst gawking at my new gauges though.:ROFLMAO:
  5. D

    Adding a water pressure gauge to 1987 70ETLH

    got mechanics wire aboard. still want gauge lol i think i know where i could put one but if anyone actually has one installed and has a pic would be great.
  6. D

    Adding a water pressure gauge to 1987 70ETLH

    I look at gauges more than most ppl would and I look at the wizz stream once every 5 mins so the gauge might save me some neck pain :ROFLMAO: . Maybe i could install a rear view camera pointed at the pee stream eh?:poop: In all seriousness its not necessary to have a gauge but the pee...
  7. D

    Adding a water pressure gauge to 1987 70ETLH

    Hi , I am wanting to add a water pressure gauge to the ol yammi- haa , I was debating between water pressure and a temp gauge and realized that the temp gauge will tell you there is a problem but maybe too late ( there is also a built in temp alarm if it still works) . A water pressure gauge...
  8. D

    VP 5.7 Gxi hits rev limiter @ 4300

    Will have to check into that thanks.
  9. D

    VP 5.7 Gxi hits rev limiter @ 4300

    throttle plate opens fully
  10. D

    Volvo Penta Drive Belt - Lots of dust and quickly wearing??

    my buddy had this problem as well on his vp 5.7 there are other posts around the internet about the vp bracket not being aligned correctly causing this issue which seems to be pretty common issue on certian years and I think they came out with a new updated bracket eventually.. Some folks have...
  11. D

    VP 5.7 Gxi hits rev limiter @ 4300

    HI my buddy has a VP 5.7 Gxi in a 24 ft Grady white offshore 24 dual SS prop (not sure of pitch yet as she's in the water ). We noticed it wont hit the rated rpm of 5000-5200 when cruising and when revving the motor in neutral she seems to be bouncing on a rev limiter at 4200-4300 rpm (if the...
  12. D

    1987 70ETLH not charging

    Well I changed out the lighting coil the old one was melted and crusty not sure if thats normal or not but I now have a working charging system .
  13. D

    70ETLH thrust washer wear

    Will do thank you sir .
  14. D

    70ETLH thrust washer wear

    Hello I was changing the prop on the new to me 70ETLH and I noticed that the brass thrust washer looks pretty worn I am not sure if this is normal wear or not but when I took the other prop off to swap it out the prop nut was only finger tight. I have included a pic of the thrust washer I am...
  15. D

    1987 70ETLH not charging

    I think i have narrowed it down to the lighting coil and have ordered a replacement, I will update the thread on if this solves my issues I appreciate all of the suggestions and help.
See more
Top