Current visitors

Home
Members

Dillusion808's latest activity

D

Dillusion808 replied to the thread 4.3gi no start new ICM. how to set base timing?.

Cracks, rust. I locked up #6 because of leaking manifold. Tried to stretch them one more season and that was a bad idea. Luckily got...

Friday at 7:40 PM
D

Dillusion808 replied to the thread 4.3gi no start new ICM. how to set base timing?.

Whens the last time you check the exhaust manifolds and elbows.

Friday at 4:26 PM
D

Dillusion808 replied to the thread 1990 OMC 4.3l Cobra ASKING FOR ADVICE.

If you can't sell it whole. The accessories should sell pretty easily if priced good. Damn things cost an arm and a leg new.

Apr 17, 2024
D

Dillusion808 replied to the thread Remove One Exhaust Bolt - Need to redo all bolts with new gasket?.

No need I've removed one bolt before and put back no leaks.

Apr 17, 2024
D

Dillusion808 replied to the thread Power Steering Cooler Replacement - Access.

No the 2 black ones under it. Could just be my eye balls.

Apr 10, 2024
D

Dillusion808 replied to the thread Power Steering Cooler Replacement - Access.

Hard to see but isn't that the steering lines going up and over the block? If not I'd take off the manifold off.

Apr 9, 2024
D

Dillusion808 replied to the thread I need help, boat runs rough and stalls. I pumped new gas and lots more.. I need help.

Can you take a pic of the notch on the pulley and the timing gauge lined up? This is jumping around so much I'm not sure steps are...

Apr 8, 2024
D

Dillusion808 replied to the thread I need help, boat runs rough and stalls. I pumped new gas and lots more.. I need help.

I think still jumping in deeper than you need to right now. I saw you pumped new gas but did you run it on a portable tank? Also might...

Apr 8, 2024
D

Dillusion808 replied to the thread I need help, boat runs rough and stalls. I pumped new gas and lots more.. I need help.

Tach doesn't always go to 0 when turning motor off. My 4.3L never did. If you are getting RPM readings I don't think its the wire shorted.

Apr 8, 2024
D

Dillusion808 replied to the thread VP 8.1 GX-i running like crap.

I like to use my test light so I don't get zapped.

Apr 5, 2024
D

Dillusion808 replied to the thread VP 8.1 GX-i running like crap.

Air fuel spark Really hard for us to help over the internet without much information honestly.

Apr 5, 2024
D

Dillusion808 replied to the thread I need help, boat runs rough and stalls. I pumped new gas and lots more.. I need help.

Jumping in late. You sure you didn't forget to tighten down the bolt for the distributor? Timing shouldn't really change just sitting...

Apr 5, 2024
D

Dillusion808 replied to the thread VP 8.1 GX-i running like crap.

What did they do to make it run last time? I'd start there.

Apr 5, 2024
D

Dillusion808 replied to the thread Moving outdrive with engine off?.

My 290 couldn't. Was hard enough using the wheel with the engine off.

Apr 5, 2024
D

Dillusion808 replied to the thread AQ280 y pipe fitment.

Project boat fun. I'd also redo the stringers.

Apr 4, 2024

Show older items

Home
Members

Top