davidmbv's latest activity

  • D
    davidmbv replied to the thread Idle issues.
    If all else fails, run a can of this stuff. It helped one I had issues with low idle. After I ran a can of tuner, it now idles nice and...
  • D
    davidmbv replied to the thread Idle issues.
    Part 35 sometimes gets stuck inside the carb and could be damaged. If you haven’t already done so, inspect part 35 that little piece of...
  • D
    davidmbv replied to the thread Idle issues.
    Also Part #35 is easy to forget /forego
  • D
    davidmbv reacted to doors67us's post in the thread Idle issues with Like Like.
    Well I popped the Welch plug out previously cleaned out the drip holes in front of the low speed needle perhaps I need to do that again...
  • D
    davidmbv replied to the thread 1972 evinrude 25hp sparkplugs.
    J6C run better on these than j4c. Stick with Champions and make sure they are gapped to spec. I have a 70,71,72 25hp Johnson and all run...
  • D
    davidmbv replied to the thread Idle issues.
    The pics attached are from the 1971 25hp Johnson service manual.
    • IMG_4258.jpeg
    • IMG_4259.jpeg
    • IMG_4260.jpeg
    • IMG_4261.jpeg
  • D
    davidmbv replied to the thread Idle issues.
    Also check the carb float and adjust per service manual .
    • IMG_4257.jpeg
  • D
    davidmbv replied to the thread Idle issues.
    YouTube : this old outboard -he has a few videos on setting link and sync on your motor somewhere .
  • D
    davidmbv replied to the thread Idle issues.
    Did you do the carb link and sync? Do you have the idle adjustment screw set accordingly? When you said it dies when throttle down...
  • D
    davidmbv replied to the thread Cowling gaskets for evinrude.
    So he responded to me within 5 min, his info is below “Hey, the easiest way is to message me through eBay like you did just now, my eBay...
  • D
    davidmbv replied to the thread Cowling gaskets for evinrude.
    Weird, he’s been super good about getting back to me. I messaged him letting him know you couldn’t reach him. He did these decals for me
    • IMG_4165.png
  • D
    davidmbv replied to the thread Cowling gaskets for evinrude.
    eBay:Vintage Marine Decals- he can do anything custom just send him a picture of what decals you’re looking for and he will make them...
  • D
    davidmbv replied to the thread 1971 Johnson 25hp Outboard - 25R71S.
    Make sure the kill switch wires are not grounded or touching anything. I found a kill switch for cheap on eBay. Get a spark tester to...
Show older items
Top