Ok all,
i was wanted to see some top speeds from 20 hp motor.
year -
make-
2 or 4 stroke -
prop -
pitch-
#blades-
size boat -
hull type -
this vid says he got 31.2 mph
https://www.youtube.com/watch?v=OIJo976P8hc
Hello all,
I am new here. I just bought a new to me 13 DuraNautic boat with a 1969 Mercury 20 hp long shaft motor. It has a 3 blade prop on it now. i saw the boat in action and it seems to fly on the water, The boat planes out almost instantly with the whale tails on it too. They seem to on...
My brother has a 7.5 evinrude '82 , needs to order some new spark plugs , shear pin and cotter pins.. what sizes are they?
my older 70 evinrude 6 hp will use a j8c or j6c sark plug not shure if they are same...
any manuals?
Re: Late 70's early 80's Evinrude Fisherman 6 hp- questions
To replace the rope, you should first remove the spark plug wires for safety. The following was taken from a 1971 service manual.
(1) Pull the rope out as far as you can, then allow it to retract less than one revolution until the...
Hello all,
this is the second motor I have picked on trade in the past week. It is a late 70's early 80's not sure of year..
Evinrude Fisherman 6 hp motor, guy said he replaced the fuel filter and carb gaskets and new impeller. i tried to start it up and the rope pulled the knot threw the...
Well I just bought this motor, guy said it was either 1945 or 1946 Sea King 3 hp engine. He said it ran about 3 or 4 years ago but takes about 40 pulls now to get it going .. never tried. What should i do first to try to get it going? What is the oil/gas mix? should I rip it all aprt to clean...
Hello all,
New to the site. My brother gave me an old engine and now i am trying to find out what it is. I asked my friend and he said it looked close to a 1955 15 hp evinrude super fastwin. But when I look at pictures of that year or all 15 hp fastwin years it does not like the case i have...