FULL-THROTTLE
Cadet
- Joined
- Feb 16, 2012
- Messages
- 17
I did not know where else to post this? I have a 2002 Polar Kraft 178TC new to me and the live well will not drain, it has the 3 way mechanical switch.I disconnected the drain line from the live well at the 3 way valve in the back and ran a plumbers snake foward and it stops at the 90 deg connection going up into the livewell. I tried to run the snake down through the drain and it wont go past the 90 degree turn. I put a garden hose in the aft end and put a hose clamp to be sure I have 100 water pressure and I don’t even get air bubbles. I put 100psi of air pressure and again not even a air bubble, (this is bypassing the 3 way valve) I do not have access to the outer bottom of the live well. Any ideas? I,m thinking I may have to put in a 4 inch access hole in the aluminum floor next to the livewell and disconnect the 90 deg drain. UGGGGGGGGG