Inline 6, Exhaust Water Jacket Installation

[WinnipegBoatMan]

I'm at the point in my rebuild, where its time to install all the exhaust parts, water jacket, baffle, and cover. Heres my question, the manuel says to install the inner exhaust water jacket with no gasket sealant, and to use resiweld on the exhaust bolts. BUT!! cant find this resiweld... and when I was talking with my outboard machine shop, they told me to use a loctite gasket material on hte exhaust gasket to make sure there is no leaking on the water jacket... Any ideas??

 

[Faztbullet]

Re: Inline 6, Exhaust Water Jacket Installation

I use the Loctite Hi-Temp Bonder epoxy as my supplier(Grainger) quit carring the Resiweld. Install the divider dry as per manual.
http://www.grainger.com/Grainger/it...Sealants and Tape-_-Glues and Cements-_-5EAL3

 

[WinnipegBoatMan]

Re: Inline 6, Exhaust Water Jacket Installation

Thanks Faztbullet! I'm gonna hunt it down, but I was doing a little research and I found out that HB fuller, the maker of resiweld, acutally opend up here in Winnipeg to make the Resiweld! Crazy, so I might acutally have a distrubuter here that can sell it to me, if not... I;m going to acklands!