Can I use this Y pipe

[jonny rotten]

It has a broken dog ear but was on the boat like that before. I took it off for an unrelated isse. Someone mentioned I could put a washer on it. Trailered so its not sitting in water. Motor is out. Id rather not spend more on parts than i already am. If I water test it before motor goes in and its good should it stay good. Clean unit. Shame to toss it but its an important seal

 

[Scott06]

It has a broken dog ear but was on the boat like that before. I took it off for an unrelated isse. Someone mentioned I could put a washer on it. Trailered so its not sitting in water. Motor is out. Id rather not spend more on parts than i already am. If I water test it before motor goes in and its good should it stay good. Clean unit. Shame to toss it but its an important seal

yeah you probably can use it with a washer to make sure it bites, could also fins a local welder to repair it. If it were mine I would weld it up and not screw around with a seal that could sink a boat

 

[jonny rotten]

yeah you probably can use it with a washer to make sure it bites, could also fins a local welder to repair it. If it were mine I would weld it up and not screw around with a seal that could sink a boat

My concern with a washer is snapping the remaining ends when I Torque it down if it's uneven pressure . It's only 26FP so I would think not and possibly the safer bet. Having someone weld it and not having it perfectly flush has it's own concerns, the o ring is mighty thin

 

[Scott06]

Having someone weld it and not having it perfectly flush has it's own concerns, the o ring is mighty thin

Would have the welder face the sealing surface on belt sander etc. If there is a local machine shop that can weld aluminum should be no issue but do as you like