I have a 1998 115 (E115SLECM) that I just bought, it's been sitting for the last 4 years. I pulled and went through the 4 throttle bodies they were pretty clean but none of the floats were adjusted the same. I did new needles, seats, floats, etc.. Also did water pump and lower gear oil, plugs, and new fuel lines. I used a new small test fuel tank and premixed 50:1 until I can verify the VRO is working. I went to start the motor and it did start a couple of times, but when it stalled it would not start again, I checked and no spark on any cylinder, I thought it might be the safety switch tether I could not get it to stay on because it was cracked. Got a new one and again, started.. Stalled, no spark! Driving me nuts Where do I start??