I have a 14' Kennedy that I bought last year. I put a Mercury 40hp classic on the boat earlier this year, installed a steering console and went for test run yesterday.
When I got the boat up on plane and trimmed motor out, I looked back over my shoulder only to see the boat was taking on water at the transom right in front of motor.
Question: How do I correct this? The cavitation plate is about 2" below bottom of boat so is my motor too deep? If so, I have about 1 7/8" that I can raise motor on transom. Would placing a board under motor on the transom stop some of the water intake?
Thanks for any advice.
When I got the boat up on plane and trimmed motor out, I looked back over my shoulder only to see the boat was taking on water at the transom right in front of motor.
Question: How do I correct this? The cavitation plate is about 2" below bottom of boat so is my motor too deep? If so, I have about 1 7/8" that I can raise motor on transom. Would placing a board under motor on the transom stop some of the water intake?
Thanks for any advice.