Search results

  1. S

    Tohatsu Tiller Handle upgrade

    Hello, I have a 2005 30HP four stroke MFS30A. It is currently hooked up to remote steering and controls. I would like to convert it to a tiller handle. Would it be possible to use the new multi function tiller handle on this outboard?
  2. S

    Tohatsu 30hp 4 stroke

    After getting my 2005 30hp 4 strk back from the dealer for blowing up ignition coils I took it out on the water with a bad outcome. The dealer said there was a wire somewhere that was shorting out and causing it to melt ignition coils and brain boxes. Luckily this was covered under warranty...
  3. S

    GPS mapping

    I fish in the Southern Yukon Lakes Region of Canada. These Lakes are great for Trophy Pike and Lake Trout. The problem is they do not have lake maps or charts for these large lakes. Does anyone know of GPS software or Mapping software that would overlay the aerial photo or topo map onto a...
  4. S

    high alt jets, Guru welcome

    I own a 2005 30hp 4strk If i rejet for higher alt, around 2300ft, At what elevation would I have to rejet back to the origianl jets? Aaron
  5. S

    30hp Tohatsu coil

    I have a 30hp 2005 4strk Carburated outboard bought new last year. At the end of last season the coil on #1 broke in half and started smoking when I tried to start it. What would cause this. Just a faulty coil or bigger issues? My dealer is a barge ride away so hoping to fix myself or take...
  6. S

    Tohatsu carb needle

    Tohatsu 2005 4 stroke 30 hp a how many turns from seated do you start from when adjusting the carbs?
  7. S

    2005 tohatsu

    I have a 2005 30hp fourstroke on a 16 foot aluminum fishing boat. I live at sea level. When I take it out on the ocean it does about 25 mph with just me and about 19-21 with two or three adults. When I take it up the pass to fish fresh water lakes in Canada, about 3,000 ft. elevation, It runs...
  8. S

    tohatsu 4stroke rpm

    I have a brand new 2005 30hp four stroke tohatsu. I took it to the lake this weekend to break it in. When I got to the time to give it the juice for a few minutes it would not come to full rpms. I installed the cables to the control box myself. I checked them out and when the shift/throttle...
  9. S

    2005 30hp tohatsu

    I have found a 2005 model fourstroke 30hp tohatsu. I was wondering if there are any issues with the year class.
  10. S

    25 hp Bigfoot

    Can a bigfoot motor be ran on a regular semi-V hull fishing boat? Thanks
  11. S

    Impeller not spinning

    Hi, Today at work my 50hp jet drive outboard took a poop! halfway through the day the shaft and impeller just quite spinning. The shear pin is in the impeller. Whats up? Thanks
  12. S

    Primer Jet

    What does the Primer Jet do? The screw head of mine is stripped some and can't be removed. It is clean. When I pull to start, fuel pools in the lake around engine. plus it doesn't start. Could this cause it? I belive the bulb stays hard. Mariner 40 EO 6E9 150368
  13. S

    Fuse

    I have a Mariner 40 EO 6E9 150368. Will it start manually if the fuse in the outboard is blown?
  14. S

    Too Much Prop?

    I have a 16' Misty River aluminum fishing boat. I currently have a 40 mariner that is about to be trashed. I found a used yamaha 4 stroke high thrust 50hp. Is the High gear ratio and prop measurements 14" in diameter and 11' in pitch too much?
  15. S

    Troll?

    Can a f40 troll mounted on a 16ft aluminium fishing boat?
  16. S

    starter

    40hp mariner 2 stroke 40 EO 6E9 S 150368. I have electric and manuel start. The Key does not turn the engine, but must be turned to the "on" position to start it manually. The key is also used to turn the engine off. What should I test and how?
  17. S

    Carb Troubles

    I have a 40hp Japanese built mariner. During rebuilding the lower carb, the primer jet screw broke apart and is now stuck inside. Also the drain screw broke off and is also now stuck. I tried a screw extracter on the drain srew and the extractor bit broke off inside the drain screw. the...
  18. S

    Who can help

    Thanks DDennis. I have bought a 40 hp japanese built Mariner. 40EO 6E9 S 150368 I can't find the year or the correct carb kit. I believe these are yamaha engines, would a yamaha carb kit fit. If so how do I find the right one. The motor has to be choked to get it moving. Then the choke has to...
  19. S

    Japanese build mariner carb kit and engine year

    I have bought a 40 hp japanese built Mariner. 40EO 6E9 S 150368 I can't find the year or the correct carb kit. I believe these are yamaha engines, would a yamaha carb kit fit. If so how do I find the right one. The motor has to be choked to get it moving. Then the choke has to be pushed in...
  20. S

    year and carb kit number

    I have just bought a 40 hp japanese built Mariner. 40EO 6E9 S 150368 I can't find the year or the correct carb kit. The motor has to be choked to get it moving. Then the choke has to be pushed in at the just the right time to keep it running. Once the choke is all the way in the motor...
Top