Search results

  1. J

    raising transom height

    I have a open LU CRAFT boat that I need to raise the transom to accomidate the newer motors with 20 inch lenght. I need to raise it approx 5 inches. The exsisting transom is in good shape. I will be putting on a 40 hp motor max. If anyone has did something like this please reply
  2. J

    60 hp Johnson won't start no fire at plugs

    I have I believe a 1984 johnson model J60TLERE that will crank but not start there is no fire to either plug. I have been using the motor about once a week thru summer and when I launched the other day it started but ran like on one cylinder. I creaped to fishing spot and turned off motor . When...
  3. J

    removing trim cylinder

    i have a 1994 evinrude 40 hp and need to rebuild trim cylinder I have the bottom bolt removed but not sure how to remove the top. On the right side there looks like a bushing with approx 1/4 hole in it . On the left side it is smooth with a hole drill ion it with a spring that acts like a...
  4. J

    tilt bleed screw frozene

    what is the best way to raise 40 hp motor manually if the bleed screw is frozen would I damage something if i put heat to it
  5. J

    info on removing powerhead 60 johnson

    I am trying to remove power head on 1985 60 hp 2 cyl. There are 8 bolts about 2 inches long holding the lower part of motor. Is it necessary to remove them?
  6. J

    motor mount 60 hp johnson

    what has to be removed to change the upper motor mount on 1985 60 hp johnson 2 cyl.
  7. J

    removing power head 60 hp Johnson

    I have a 1985 60 hp Johnson 2 cyl that I am trying to remove the power head from the rest of the motor. I have remove the lower unit, I have removed all cables,wiring, hoses ect. I have removed the four bolts that bolt the power head to the lower part of motor they are in rubber shock mts. The...
  8. J

    lower unit seals

    I have a 1998 40 hp rude that I am trying to replace the lower unit seals. I am having trouble removing the bearing housing. I made a puller using 1/4-20 threaded rod and have put enough pressure to snap one of the rods still have not been able to remove and help or suggestions will be appreciated
  9. J

    9.9 won't start

    I have a 9.9 yamaha that wont start.It ran fine the last time I used it about 2 months ago. When I try to start it does nothing . I am getting fuel to the carb. but the plugs seem dry, It has an auto choke ,by the way it is a 4 cycle.Is there something that I might check. I don't think it is...
Top