The iboats forum moderators are excited to announce that at this time it appears the iboats forums posting pictures function is working once again. Though we cannot promise for how long, we're hoping for indefinitely.
Untill I can come up with a way to put a new steering system on my old grady I need to know how to connet to my 92 Johnson 88hp
is there an adapter or something that attaches to the tongue on the front of the motor?
Thanks,
Ralphw
I have a dilemma. I have a fully restored 1961 Grady White with the original 1960 starflite motor. the motor has been well taken care of and I replaced many parts lower unit seal bearing ..all rubber hoses belt etc. The motor runs very nice, looks great. but it is 46 yrears old and I will have...
I was looking at an evinrude outboard on ebay that is not too far from me and it caught my attention, but the seller said it was a mid 70s 85hp with this model number E05466<br /> I emailed him twice to make sure and he says its right... I can't find it anywhere.<br /><br />heres the link and it...
I'm struggling trying to get this seal out..<br /> <br />My manual says to just buy the whole assembly(cap-bearings-seal). It shows nothing in the way of removeing/replacing the seal. The part number on the cap is 307089.<br /><br />I guess my question is does anyone know how to get this...
this is a 2 part question.....<br /><br />I have water in the gearcase of the 75 starflite I'm working on. I have the Seloc manual which covers a variety of motors. all is going well till I get to the driveshaft.<br /> it says not to remove the bearing housing shown in picture that it could...
Hello, forgive my ignorance but I want to get my motor running tomorrow. I have it on a stand I built. its a 1960 75hp evinrude, I have no doubt about the sturdyness of the stand, and would use one of those big plastic garbage cans you see landscapers use,, maybe 45 50 gallons.<br />I guess I...
hello,<br />just started a restore of this motor<br />ran well 10 years ago<br /><br />this has a magneto ignition<br /><br />my question is: if i touch a continuity checker to the bolt that comes out of the side of the distributor body(black lead wire attached) and touch the housing I get...
I have a 1961 18 foot wooden lapstrake grady white that I am restoring.<br /><br />I would love to roll it over if I could think of some safe easy way to do it with out harming the boat.<br /><br />any suggestions?
On my restoration project I am replacing the transom....can I use SS screws to fasten to the plank ends where the bronze used to be? they will be hidden by filler and paint. it is a solid mohagonay transom attaching to a ply hull.<br />thanks.<br />Ralph
ok Just got this motor on the back of a 1960 Grady white, restoring the boat and motor<br /><br />turned over did not fire up<br /><br />can't seem to get the glass float bowl full with old hose...getting new one tomorrow. It gets about 2/3 full.<br /><br />also there is a small black wire...