Search results

  1. R

    Yamaha 30 SG carb emulsion tube

    Anyone know if this is available? It's the emulsion tube that slides in under the main jet #14. Someone mangled the tubes and main jets. Need the part number for tube/nozzle if available.
  2. R

    Ethanol Gas Observations

    Decided to run 87 Octane E10 in my 1983 Johnson 90 hp V4. First thing that happened was a couple of days later, an old plug made of JB weld in the bottom of my tank softened up and 15 gallons drained to the ground. Yea that hurt, ha ha. Anyhow, after running a few hours, I pulled the plugs and...
  3. R

    2016 Alumacraft transom rotted completely out.

    Bought a 2016 15/42 Alumacraft from a guy I work with. It looks like new except some slight marks where a trolling motor was clamped onto the transom. Upon a closer inspection once I got it home, I discovered all the wood had completely rotted out of the transom. I pulled the nails holding...
  4. R

    Johnson J90TLCNB 1982 90 hp; speedy sleeve for driveshaft?

    Ok, this old 90 has some slight pitting on the driveshaft from salt water right where the seals ride below the water pump where it enters the housing. I don't really care to put a new driveshaft in her as old and rough looking as she is, plus I'm not sure I could even get the bearing carrier...
  5. R

    Johnson J90TLCNB (1982 Johnson 90 hp with power tilt and trim) Timing Advance Specifications

    If you have a factory manual for this motor, can you see what the advance should be set at when wide open throttle.
  6. R

    1982 Johnson 90 hp carburator question.

    The model number is J90TLCNB. Has power tilt and trim. I've noticed that if I trim the motor up a little while idling, it starts to cough and idle a little rough. If I trim it all the way down it idles perfect. I assume it has something to do with the float adjustment or needle. Anyone have...
  7. R

    Rectifier/Regulator on 1982 Johnson V4 question?

    Motor model number is J90TLCNB so it's a 1982 Johnson 90HP long shaft. Motor sat up probably 10 years in a pasture. Was a sight to see for sure. On top of that it was run in Salt water occasionally. Anyhow, I got the thing and hauled it to the house and started working on it. When I pulled...
Top