Search results

  1. 1

    The saga continues

    Hi all got my hands on avo analogue meter continued testing found one channel down on stator,ordered and fitted stator from cdi ignition Usa,still had misfire swapped cdi units about etc until identifying that it was cdi supplying 1&2 cylinder replaced that cdi pack started up in anticipation of...
  2. 1

    Hi all so back kind of after a rebuild as found broken rings not causing any problems but once seen

    So run up not firing 3 or 4 I’m off with having hip replacement done so loads of time to think my fear is if I have a stator trigger or rectifier fault I was thinking of changing the leads on cdi packs but reading if there was a problem with above could blow cdi so are there test procedures I...
  3. 1

    Force 1989 125 question

    Hi all finally got rebuild all done been down a year I am just hooking up electrics have a question on trigger wires ? 8 wires 2x white and green 2xorange 2 red 2xgreen do I have to identity which wires are for which cylinders ? Or just follow wiring colours on end of block diagram if I have to...
  4. 1

    Force 125 lacking power

    Changed fuel pump diaphragm fuel filters cfi cross over valve bodies checked butterflies open fully boat will only reach 4000 rpm 30 mph and feels like if it were a car you pull away in second gear it starts runs no faults pulls tubes etc all day compression all good owned for years used to go...
Top