Search results

  1. P

    Tilt/Trim wiring question

    I have a 1987 Starcraft 161 for 5 years now. I am replacing the two Tilt/Trim relays (solenoids) and noticed that the red wire with the 20 amp fuse was hooked up but was not being used. I have attached pics to show that the harness from the relays has three prongs but the mating harness only has...
  2. P

    Control box neutral safety switch

    Hi folks, I just bought a 1987 StarCraft Medalist 1601, and the first thing I need to iron out is the neutral safety switch. I completed a compression check then put the muffs on the engine to run it a bit. I turned key & nothing. I ran to the internet and read that it may be the neutral safety...
  3. P

    Neutral safety switch

    Hi folks, I just bought a 1987 StarCraft Medalist 1601 (I think), and the first thing I need to iron out is the neutral safety switch. Everything was fine as I checked my compression (160 all four cylinders) but after I put it all back together, turned key & nothing. I ran to the internet and...
  4. P

    Mercury 60 HP

    Hi everyone, I am rebuilding the carbs on my 1988 Merc 60HP ELO, serial # 0A740965. Can someone walk me through the float re-install? (best method plus exact measurements I'm looking for). Also, I think my fuel pump is fine but is there a performance test to know for sure?
  5. P

    1988 Mercury 60HP

    Hi folks, Took a chance and bought a Merc that sat a couple of years. Drained most of the old gas from the carbs and started it yesterday using high idle. I was able to lower the idle speed but the engine would misfire and it would stall at the lowest idle. Shot some carb cleaner into the two...
  6. P

    1988 MERCURY 60 HP ELO cable confusion

    Hi everyone, I have been getting advice from the iboats forum for years but just became a member. I just bought a 1988 Merc 60HP ELO, serial # 0A740965. Don't even know if it runs. I have to trust the guy I bought it from who said it ran great when he stored it 2 years ago. Before I can even get...
Top