The iboats forum moderators are excited to announce that at this time it appears the iboats forums posting pictures function is working once again. Though we cannot promise for how long, we're hoping for indefinitely.
I have the Command Link Multifunction Meter (Square) for tach and one for speedo/fuel management. I tried to re-set the trim gauge to zero, because it was off by 1-2 bars when trimmed fully down. Followed the instructions on page 13 of the Command Link Operation Manual(part#6y8-2819U-00). Now...
Talked with Yamaha tech support(Mark)today and he/they are at a loss as to why the Command Link gauge shows everything except depth. There is a possibility of a bad gauge. I'm not sure I want to go through time and expense of trouble shooting this. One way is to connect a known good...
I recenlty got a new boat with new Yamaha F250. Motor has just over 2 hours on it. Time and RPM according to the break in schedule. Never been to WOT, just a short cruise in Coinjock canal to get over the 2 hour mark.
Anyway, after installing Blue Sea System Batt switch and auto charge...
2001 Maycraft 1900<br />2002 Yamaha F115TXRA 25" shaft (approx 100 hrs)<br />current prop is SS stiletto 13x17<br />with one person and 35gal of fuel<br />WOT is 5200. Never been more than that. Runs pretty close to that fully loaded. It has been suggested that I change to a smaller pitch...
I have a 2002 Maycraft 1900 CC; 2002 F115 Yamaha 4 stroke; tralered on a Load Rite 203100102SA; towed with a GMC Sierra 5.3L 4wd, 4.10 rear end. With the boat motor fully tilted up,and the lock in place, one corner of the engine housing rested slightly on the tie down strap. I was still able...
I have a 2002 Yamaha F115TXRA. I just installed 2 multi function gauges, speed and tach using the Yamaha supplied wiring. The gauges appear to be working correctly, and I do not have any wires left over. However, the gauges have no lighting. What did I miss?<br />Thaks for any help!!<br />david
