Search results

  1. jerryjerry05

    No spark?? F9. 9SMHB 4stroke

    2013 4st. 9.9 F9.9SMHB 1035097 No spark either cylinder. Test procedures? Thanks,Jerry
  2. jerryjerry05

    The fall

    Last week I found how far down the ground is. I tripped over a jack stand and landed on a Mercruiser lower unit and a electric scooter. I thought I broke my arm/shoulder. Nope, just scraped and bruised everywhere. Haven't been able to move good or at all. Younger, I would have bounced, not...
  3. jerryjerry05

    1993 30 hp C30ELRR Hard shifting??

    Shifter is REALLLLY sticky not sticky but stuck. Need to really push/pull to make it move into gear. The gear box is ok and shifts good. It was just resealed. The shift handle will come off. Any tips or tricks? I hate to think I have to dismantle the motor to pull the shifter. This motor has...
  4. jerryjerry05

    Here's one for the books!!

    2014 Yam115 4stroke. The aftermarket Sierra developed a pin hole leak and saturated the lower half of the motor, including the starter. Went to change the filter and clean the oil. Took the starter and all the electrical connections apart and reassembled everything. Went to start it and huge...
  5. jerryjerry05

    MISSING!!!!!

    A post in the repair section in the first posts is missing. The carb link and synk is MISSING!! The one by FrankA is gone. It goes to a post about fixing a 454 Mercruiser. HELP!!!!
  6. jerryjerry05

    2006 VZ225TLR 2006 help?

    2006 225 good comp all 6 good spark. New low pressure pumps and new high pressure pump 60# Starts and when put in gear it diesels up and down fast about 1/2 second wave. Any ideas? Thanks
  7. jerryjerry05

    2006 225 VZ 225TLR No spark on #1 and #5

    Starts but still runs bad. Did a spark test and found no spark on #1 and #5 Swapped coils and still no spark. Good comp. fuel pressure 55# Thanks Found out it's not supposed to fire when in N Anyone know why? Started it and tested spark in gear both 1 and 5 have spark. This has been quite a...
  8. jerryjerry05

    Runs bad.

    2006 225 VZ225TLR First what's the fuel pump pressure supposed to be? I test it and it comes out at 55# Comp 120/6, spark ok. Start it and it idles, when put in gear and accelerated it revs up and down fast again and again and will smooth out when put back in neutral. Does it every time...
  9. jerryjerry05

    Water not coming from pee tube.

    2003 Yam 200TXRB About 300 hrs. Motor starts and runs fine. No water from pee tube, even if taken loose at the rectifier. Tried weed eater string up in the rectifier and nothing. Should I try taking the rectifier apart? Would this make the cylinders overheat? Temp was high on the center cyl...
  10. jerryjerry05

    4 stroke air /fuel screw setting

    2005 250 Yam 4stroke. My friend thinks he knows how to set these screws. He saw somebody do it using the gauges and says he can do without them. It's his motor and it runs like crap at low speed. Anyone know how or if it's printed how to do it someplace? Thanks
  11. jerryjerry05

    Year ?

    LF225TXR Ser#1007840 Letter "K" on bottom of the tag. The year sticker is missing. Any idea or how to figure out the year?? I tried. THANKS
  12. jerryjerry05

    1983 60 hp Evinrude shift rod height???

    60 hp 1983 need the shift rod height?????The shaft is 20-21" Somebody just beat the shift mechanism to death and I had to replace it. THANKS Went to the site where this info is usually listed(Top Secret File), every time I try to open it, it goes to a post about a Chrysler motor and if they...
  13. jerryjerry05

    NO GO!!!!???

    2000 115 txry(?) 2 stroke. Starts great and runs all day at an idle. Give it gas and it dies. Won't rev up. Not overheating, good gas, carbs spotless, good comp all 4, good spark, fuel pump new, plugs good, linkage ok, motor seems to be in good shape, just no go. """GUESSING???"""Is it...
  14. jerryjerry05

    Clouded gauges???

    Saw on this site(somewhere) a link to a site that cleans the clouded/scratched lenses on the gauge. Anybody have that site/link??? THANKS!!
  15. jerryjerry05

    Trim@Tilt locked in the up position.2005 150 2stroke

    The motor turns but no movement up or down. The oil's full. The release is locked in place, won't turn. Any ideas? Any rebuild places cheaper than 5 Star? Easiest way to remove the unit? Thanks
  16. jerryjerry05

    2004 150 Yam buzzer going off.

    2004 Yam 150 carb.150TXRD The motor runs GREAT up to 3800-3900 and then the alarm starts. It's NOT overheating, I used a heat gun and checked the temps on each cylinder. Not getting anywhere's near hot. New water pump impeller. The owner replaced both oil sensors/senders in the tanks. Any...
  17. jerryjerry05

    2006 225 4stroke runs poor until warmed up.

    2006 225 4stroke. Starts right up but runs crappy for about 10-15 min. Won't accelerate without missing. Then when warm it smooths out and you can give it gas and it runs good. Fairly new plugs, 175-180# compression. Started and pulled each plug wire and each cyl. would drop until the wire was...
  18. jerryjerry05

    Seadoo GTX 4 tec

    Is there a Seadoo repair forum other than this, or just ask here? 2004 seadoo gtx 4 stroke supercharged bombardier(heck of a name) Have a pair of them, they sat for 4-5 years and one doesn't want to turn over. New batteries, one just clicks and the starter engages but only groans and when the...
  19. jerryjerry05

    1999 Johnson T@T Airbound?

    1999 225 Johnson Trying to fix the T@T Might be airbound? Bad motor, replaced, added oil and motor works but won't go up or down. The release works or should I say it turns. Thanks
  20. jerryjerry05

    2005 90hp Yam no spark.

    2005 90TLRD 1017108 Guy calls and says his motor has no spark. What's the first thing I should be looking for? I haven't looked at it yet, probably tomorrow. I have a DVA Thanks
Top