Search results

  1. B

    1986 johnson 8hp

    Gotter, tks
  2. B

    68 Johnson 9.5

    50 years ago i had a 68 9.5 on a 8' Seaflea, with a brass 2 bladed racing prop and blades cupped . Blew the doors off everybodys 50 mercs on the lake. Had a couple since, on a small lite boat, you look at the wake behind the motor, it should be going a significant amount faster than that
  3. B

    68 Johnson 9.5

  4. B

    1986 johnson 8hp

    Thanks thats what i needed to no, i tryed a welding torch cleaner wire, but the one i used was maby a Little big. The nipple seams ok, but i didnt want to go poking to hard, not nowing if there was a jet or spray nossil i could damage.
  5. B

    1986 johnson 8hp

  6. B

    1986 johnson 8hp

    Ok Oka so after the brass nipple it an angled hole. Thats where my problem is. Primers pushing fuel to nipple ok, nipple's not plugged, but fuel aint going down the angled hole. As soon as i apply more pressure on primer, it just sprays out around where hose clamps to nipple. No gas getting to...
  7. B

    1986 johnson 8hp

    86 to about 89 6&8hp johnsons didnt have a choke button, they have a primer pull push button. The gas line to the fuel pump and pump to carb bowl are good, one is a clear line you can see fuel going to the carb. The primer has a small gas line that goes from the primer to a fitting just behind...
  8. B

    1986 johnson 8hp

    No. When i squeeze bulb on fuel tank hose i can see gas going thru the gas line to the carb (its a clear line). Its plugged where the primer gas line goes into engine
  9. B

    1986 johnson 8hp

  10. B

    1986 johnson 8hp

    When i pump up the ball i can see gas going thru line to carb bowl. Its that little skinney line from primer to fitting thats just back of where carb bolts on. Its a thin brass fitting. But the primer feels so hard to pull that the pressure is forcing it to spray out around the hose. I was just...
  11. B

    1986 johnson 8hp

    Replaced all gas lines, then noticed when i use primer it was leaking. Replaced it, when you hit primer it sprays out at fitting behind the carb, redid it 3 times, primer is hard, i think it is blocked behind carb, no gas getting thru. The only way to start it is pull a plug and put a little in...
Top