Search results

  1. nola mike

    '95-ish Glastron SSV195 carbureted mercruiser 4.3 starter solonoid wiring color codes

    The oil pressure switch is probably bypassed. Power likely comes off the purple ignition wire somewhere, maybe coil positive or choke. Follow the positive back from the pump to see where it goes.
  2. nola mike

    Alpha one gen one Y plate is it adjustable?

    It isn't really adjustable, but a corroded/sticky pivot bolt can keep the plate from moving freely. The return spring can also have the wrong tension, which may make the plate harder/easier to move in one or both directions
  3. nola mike

    Smoking Engine and Mercruiser ignition switch question

    My thought as well. Or something else fried under the helm.
  4. nola mike

    Mercruiser 170/470 Starter Question

    Interestingly (?) the older 470s only had 1 on the starter.
  5. nola mike

    1990 Rinker 18.6

    Here: https://forums.iboats.com/threads/how-mercruiser-thunderbolt-ignition-systems-work.676476/ You're reinventing the wheel. The module is NLA, how do you know what you replaced is good? Yes, the ignition trigger in the dizzy is a fairly common failure point though yours should be the...
  6. nola mike

    1997 5.7l water in oil. replace?

    Always feel like I'm taking crazy pills when I say this, but the plugs on my 2001 were brass, or at least non ferrous gold metal of some sort. The HG was also composite ...
  7. nola mike

    Winterizing 3.7l mcm 224 165 hp mercruiser

    Easiest motor ever to winterize. Step 1: unscrew the aft plug on the heat exchanger. Step 2: laugh at the rest of us and drink a beer. (Assuming no power steering) That will keep everything from freezing. The rest is normal maintenance common to all the mercs, I do everything between winter...
  8. nola mike

    TD-14 (Hurricane Milton)

    Just heard from him. Ok but I think out of beer already and running low on whiskey
  9. nola mike

    TD-14 (Hurricane Milton)

    Last night at 9 said he had limited cell service. Waiting to hear from my mom as well
  10. nola mike

    TD-14 (Hurricane Milton)

    You have a generator or did you spend all your money on the whiskey?
  11. nola mike

    TD-14 (Hurricane Milton)

    Ugh. My mom "evacuated" about 1 mile in in Nokomis. Didn't listen to me to GTFO. Going to be about the worst place for the surge. Helene wiped out all the dunes already.
  12. nola mike

    Upper and Lower Drain Plug Merc Sterndrive Alpha 1 Gen 1 Question

    As @Scott06 said, check for a stuck gasket. I'd guess that without that gasket you'd get much more than a bit of water in the oil
  13. nola mike

    4.3 L block coolant capacity

    Did you poke out the drains?
  14. nola mike

    Gimbal bearing puller

    Iirc I used a bearing puller with the bell housing still attached. I do know last time around the engine was out and I knocked it out from the inside. That made for an easy job.
  15. nola mike

    Mercruiser 170hp 470 no spark

    So it's the shift interrupt?
  16. nola mike

    Mercruiser 170hp 470 no spark

    Tap on the tach and wiggle the wire when running and see if it hesitate/stalls
  17. nola mike

    1990 Rinker 18.6

    That engine should be TB4, no points. Check the stickies for the troubleshooting guide.
  18. nola mike

    2006 Monterey Boat with a 4.3L Mercruiser TKS Engine S/N 0w354897 Mysterious Loss of Power

    Revving with no load tells you nothing. If there's water in the tank it's initially layered at the bottom and not necessarily picked up. As the boat bounces it gets emulsified in the gas and then sucked up. You stop and it separates out again. How does it get in? You're surrounded by water with...
  19. nola mike

    Wooden Mounting Base with Casters for Mercruiser 4.3L 1992 Engine

    This has a lot of numbers on it. https://samerwebapp01apncus01.azureedge.net/mmgw-env-b/filer_public/d5/0d/d50d7c7f-af61-4515-8645-67e81e46d8db/43l_alpha_4v_installation_drawing-865108r89.pdf
Top