Search results

  1. The Force power

    The fall

    I broke the fifth metatarsal bone by just stepping on a handle of a screwdriver & still hurts from time to time (aging sucks!)
  2. The Force power

    Need to adjust the dial 1990 Force carbs mixture

    In my experience..........I start at 11/8 from out & yes out = rich mixture / in = lean MAKE SURE; all carbs have to be set the SAME IN ADDITION; 7. Adjust idle speed to 700-750 RPM in the water in forward gear. Do this with the screw on the bottom of the timing tower. Loosen the locknut and...
  3. The Force power

    1984 force 125 Leaking tilt and trim?

    Then all is good ;)
  4. The Force power

    Why does everybody hate Force?

    You nailed it!!
  5. The Force power

    Why does everybody hate Force?

    Totally agree!
  6. The Force power

    The fall

    Auch!! sorry to hear this Get well soon
  7. The Force power

    1984 force 125 Leaking tilt and trim?

    :D :D:D Cadillac quality only
  8. The Force power

    1984 force 125 Leaking tilt and trim?

    As long as the water level is not reaching the powerhead. If that? than the motor is sitting too low in the water
  9. The Force power

    1984 force 125 Leaking tilt and trim?

    Your seal must be one of the very few :) the material used was to deter water from entering but nowhere near "waterproof"
  10. The Force power

    Force outboard maintenance

    I think....... Fuel stored in a sealed container/tank last longer than exposed to air. I ran the last fill up with fuel stabilizer / I tape-up the tank-vent on the boat when I park it for the winter October to June is how many months? Prime the fuel system & she fires up within 20 seconds
  11. The Force power

    1990 Force 120HP #2 Cyl zero compression and upon opening piston shows damage

    THE YELLOW WIRES going to the CDI-modules GENERATE THE POWER FOR THE SPARK, they NEED to be hooked-up Make sure the kill-circuit is open/ not grounded I send you a PM on how to check the ignition/Ohm readings etc etc. I.....would change all the connectors on the trigger-wires/check condition of...
  12. The Force power

    1990 Force 120HP #2 Cyl zero compression and upon opening piston shows damage

    Move the wire leading to coil #3 to #1 and see if it sparks? IF it does; check the trigger-wires/connector for #1
  13. The Force power

    Is this a L drive or not?

    I see a hydraulic-pump is this for the trim or steering?
  14. The Force power

    Is this a L drive or not?

    You're probably right! all I know is the splines from an outboard block will not fit on the Jet-drive :)
  15. The Force power

    Merc 125HP on a 1996 Trophy, no spark and would not start before that

    He's not sure; what (year) he has BTW the picture posted is not from his motor
  16. The Force power

    Is this a L drive or not?

    Sorry, I thought I mentioned it in previous post but yeah I scored that one a couple years ago for cheap ($250 for two) stripped one & sold off the rest in parts. The one referring to that is a "spare" had low head pressure on one cylinder, ended up being a blown head-gasket :D Kept it for the...
  17. The Force power

    Is this a L drive or not?

    lol A 40 HP ??? I don't think is going to move very well :D I'll use my 90 HP.
  18. The Force power

    Is this a L drive or not?

    The same goes for the Jet-boats that had the 90 HP & 120 Force engines, the splines on the crank-shafts are different.
  19. The Force power

    Is this a L drive or not?

    It may in some cases however in this case I doubt it, judging by the bottom-shell looks the same as the outboard except the cut-out for the out-drive
  20. The Force power

    Is this a L drive or not?

    Thanks, my thoughts also (except the 115 HP want to use the spare 90 HP i have)
Top