Search results

  1. C

    1985 evinrude 30 hp prop power issue

    I hate hope! I had the cover off and was pinching the line to the carb bowl off. Didn’t change anything.
  2. C

    1985 evinrude 30 hp prop power issue

    Just holding like this it ran better
  3. C

    1985 evinrude 30 hp prop power issue

    Just pulled plunger and housing for primer apart. Cleaned both fitting nipples. Some crap in smaller one. Was missing o ring on shaft behind plunger handle. Put one back. Ran to the river quick. Ran same. Did notice it would wind up more when I held the plunger out just a crack. Any ideas with...
  4. C

    1985 evinrude 30 hp prop power issue

    You’re right. It’s a hose fitting/jet. I pulled it out and cleaned it out when I was doing carb
  5. C

    1985 evinrude 30 hp prop power issue

    Going to see if I can pull the priming plunger out of housing today. Any tips on not breaking it?
  6. C

    1985 evinrude 30 hp prop power issue

    Cleaned with carb detail brush and then replaced with carb kit part. No improvement. (This was done 2-3 attempts ago)
  7. C

    1985 evinrude 30 hp prop power issue

    Can I just jump the primer? Put a coupling nipple between lead and send pines?
  8. C

    1985 evinrude 30 hp prop power issue

    It’s firing on both. I’ll check the reed valve. Thanks guys!
  9. C

    1985 evinrude 30 hp prop power issue

    Good compression. Did the carb rebuild kit. Yea it has a primer. That can cause rich at high speed?
  10. C

    1985 evinrude 30 hp prop power issue

    New plugs new coils still only running half speed. Seems to sputter when throttled all the way. Too much fuel in mix?
  11. C

    1985 evinrude 30 hp prop power issue

    Yeah. Just did a running spark check. Ran on one plug not the other. So was getting tricked by a bad spark. Followed it back to what seems to be a bad coil.
  12. C

    1985 evinrude 30 hp prop power issue

    Did cam follower pickup and throttle control adjustment. Don’t have a timing light though. Saw a post here that they’ll run on one cylinder so checked spark and is ok on both plugs. I also tried hand choking the air and it killed. Thinking it’s a fuel supply issue. Checked bulb while running in...
  13. C

    1985 evinrude 30 hp prop power issue

    Dumb question. In part 2 of cam follower pickup it references throttle control lever. Is it talking about the grip throttle or the thing under the throttle control rod on the side?
  14. C

    1985 evinrude 30 hp prop power issue

    That was mid carb removal. Clip is missing yes.
  15. C

    1985 evinrude 30 hp prop power issue

    Doesn’t look the same.
Top