Search results

  1. R

    '74 Evinrude 9.9 Issue

    Got it. We have been testing the motor on a jon a boat in our stock pond. And have been trying to make adjustments on the water. We can get it to run at WOT, but the low speed adjustment needle has to be set very lean, when you come off the throttle though, it just dies.
  2. R

    '74 Evinrude 9.9 Issue

    practically no movement of the pistons. I’m getting the new carb kit tomorrow and will be installing the new nylon bearing for the slow speed needle, we’ll see how it behaves after that. If that doesn’t fix it, then I’m going to the ignition points next.
  3. R

    '74 Evinrude 9.9 Issue

    All of that looked good, rings and all.
  4. R

    '74 Evinrude 9.9 Issue

    Yeah I have read others who have had similar numbers, but still ran strong. We did replace the head gasket as well, the original one was actually in decent shape.
  5. R

    '74 Evinrude 9.9 Issue

    Just a quick follow up, I removed the slow speed adjustment needle and found that the little nylon bearing was brittle and broken into small pieces. I used a small wire to loosen them and tapped the carburetor so they would all fall out. I am getting another nylon bearing to replace it. Could...
  6. R

    '74 Evinrude 9.9 Issue

    Compression numbers were both about 60.
  7. R

    '74 Evinrude 9.9 Issue

    I will check on that thanks. We did replace the fuel pump with a new one but I guess anything is possible at this point.
  8. R

    '74 Evinrude 9.9 Issue

    Hello, My father had an old ‘74 evinrude 9.9 laying around in the garage for about 20 years and my son and I decided to get running again. We have spent the last 2 months on and off working on it and even repainted it. Looks brand new once again. We got it running really well on a stand so the...
Top