Search results

  1. Bondo

    Erratic timing and Vacuum

    Ayuh,..... Who adjusted the valves,..?? 'n How were they adjusted,..??
  2. Bondo

    OMC cobra new long block back firing when first starting

    Ayuh,..... Welcome Aboard,....... What killed the old motor,..?? Generally speaking, a lean condition would be my 1st guess, or the timing is off,...
  3. Bondo

    MerCruiser 5.0 (Carb Engine) will not turn, what is this part?

    Ayuh,..... At the keyswitch, with a test light, is there power at the battery terminal,..?? Usually a red wire,... With the key "On", is there power at the ignition terminal,..?? Usually a purple wire,.... With the key to "Start", is there power at the start terminal,..?? Usually a yellow/ red...
  4. Bondo

    4.3 vortec Mercruiser..lots of questions

    Ayuh,...... Welcome Aboard,...... Only the Long Block would be used, all of the other parts, 'n pieces will come from yer cracked motor,....
  5. Bondo

    Old Mercruiser 120 3000rpms WOT rated for 3900-4300

    Ayuh,...... As per Kenny, that would be a good place to start,..... maybe a 15" if you plan on towing water toys,....
  6. Bondo

    Volvo Penta 3.0 4 cylinder engine won't start

    Ayuh,....... When you take the distributor cap off,.... There'll either be a set of points starring back at you,.... Or, an electronic trigger of some sort that tells the coil to fire,.... 'n Yes, I've set 'em with a matchbook to get it running enough to get to the shop, where they...
  7. Bondo

    Crank no fuel - oil pressure safety switch ?

    Ayuh,..... As in the diagram from AD, the fuel pump is fed power from 2 points,.... It primes when the starter is engaged from the outside tiny terminal on the starter's solenoid,.... When the motor starts, the power is fed by the key switch, in yer case, off the coil's terminal, through the...
  8. Bondo

    Coil Question

    Ayuh,...... Welcome Aboard,....... Yer problem sounds like a key switch issue, definitely not a coil issue,....... With a meter, or test light, test the key switch, before you start blowin' money on anything else,.....
  9. Bondo

    Very difficult to shift into Neutral

    Ayuh,..... Welcome back gator,...... To fix yer idle problem, set the idle screw to 650/ 700 rpms(spec),.... It should be the same, in the water, or out, in gear, or not,..... If it stalls, odds are it needs to be richened up abit,....
  10. Bondo

    Carburetor switch

    Ayuh,...... Have you cleaned, 'n rebuilt it,..??
  11. Bondo

    Volvo Penta 5.0 GXI Exhaust riser won't come up to temp

    Ayuh,......... Welcome Aboard,...... So what does it do, running with a load, on the water,..??..??
  12. Bondo

    Carburetor switch

    Ayuh,...... Welcome Aboard,....... It might, or might not,..... Why not just rebuild the carb that's on it,.....
  13. Bondo

    1973 Gibson help

    Ayuh,..... Which is not a standard well known motor, which we can't see,.....
  14. Bondo

    Old Mercruiser 120 3000rpms WOT rated for 3900-4300

    Ayuh,.... Have you tried a smaller prop,..?? Is the drive original,..?? If not, is it the right gear ratio,..??
  15. Bondo

    1973 Gibson help

    Ayuh,..... Welcome Aboard,..... There should be a heat exchanger where the antifreeze is cooled by the raw water from outside the boat,.....
  16. Bondo

    81 sunrunner omc800 3.8 sterndrive issues

    Ayuh,...... Welcome Aboard,..... Usually there's another set of holes in the controller that moves the cable in the opposite directions,....
  17. Bondo

    Volvo Penta 3.0 4 cylinder engine won't start

    Ayuh,.... Welcome Aboard,....... Did you service the points,..??
  18. Bondo

    What does HEI / D.U.I. replace

    Ayuh,...... Welcome Aboard,...... Are you sure it's not just a key switch issue,..??..?? Have you tested it with a meter, or test light,..??..??
  19. Bondo

    No Fire

    Ayuh,...... The points fire the coil, so service the points,....
Top