Search results

  1. Faztbullet

    No blocking diode in slow mode VE115TLETS wiring harness????

    I doesnt know as previous posts have stated. Pull the carbs and cleam and install new gasket kits. Never reuse old gaskets
  2. Faztbullet

    No blocking diode in slow mode VE115TLETS wiring harness????

    No diode as engine does not have SLOW or Fast Start features
  3. Faztbullet

    1996 Evinrude OMC VRO Intermittent No Spark

    Yes you will need to check max timing as the castings can be off and advance/retard max °
  4. Faztbullet

    evinrude/johnson v8 buying

    https://bangshift.com/bangshiftxl/watch-3-6l-2-stroke-evinrude-v8-powered-sand-rail-make-ear-splitting-sounds-ever-dyno/
  5. Faztbullet

    AMS Oil 75W90 or Evinrude Lower Unit Gear Oil

    Dino oils have Extreme Pressure Additive (EP) of sulurized olefins and phosphorus. The also contain "yellow metal" sulfur buffering additives used for anti-corrosion that keep sulfur chemistries from attacking any copper alloy (brass or bronze) components. Synthetic oils have high heat...
  6. Faztbullet

    Water pump tell tale

    It is part # 69555001
  7. Faztbullet

    90hp Merc 3cyl reaches 3000RPM but takes awhile to go over 3000RPM

    Check spark
  8. Faztbullet

    Ultrasonic cleaners?

    I use formula 88 from HD mixed 50/50...be surprised on what comes out of a clean carb
  9. Faztbullet

    1998 Johnson 175 Ficht Not Starting

    Test output to ignition module from ECU
  10. Faztbullet

    evinrude/johnson v8 buying

    Lot of them old dinosaurs have went to the scrap yard. Go to Facebook Strictly OMC as some of the old timers may part with one. Certain parts are scarce. If you want 300 HP buy new as they are lighter than the V-8
  11. Faztbullet

    1998 Johnson 175 Ficht Not Starting

    Have you tested the ignition module?
  12. Faztbullet

    No power to trim or motor

    Do you have a battery switch? If so look for loose connections
  13. Faztbullet

    93 manier 75 hp

    No its #38
  14. Faztbullet

    1998 Evinrude 90 SPL WORTH

    Sounds like whoever rebuilt it did not fix the original problem of why it failed the first time...$300-400 at best
  15. Faztbullet

    1985 Johnson 150 idle surge

    Ignition problem.. start by disconnecting the harness and then jump starter. If it runs OK the problem boat side. Also you will need primer on to kill it or rags stuffed into carbs if you do this. Check the voltage from stator to packs and if you bought a CDI brand timer check Amphenol pins in...
  16. Faztbullet

    Problem removing Water Pump base on 50hp outboard

    Well your going to need a new one first. Then apply 10psi air into unit, use 2 coated decking screw 3.5 inches long, thread into base and use 2 cats paw pry bar and pull up on it evenly
  17. Faztbullet

    No shut off

    Could be missing gound on blk wire at switch also
  18. Faztbullet

    1992 Evinrude 150 aluminum in cylinder

    What a hack video!!!! There is no way to wash out honing debris from cylinder ports and crankshaft area. Those new pistons are now worthless. I'll bet motor did run more than 10 hrs before it failed again
  19. Faztbullet

    1992 Evinrude 150 aluminum in cylinder

    Do not rebuild it till the block is sent to be pressure tested. The early models are bad about water leaks into cylinders from factory glue lines especially #1. The sleeves can be pulled a welded and re-sleeved but not worth it as 91 is a year all to itself, 92-93 are all to themselves.
  20. Faztbullet

    1986 Mariner 40HP 6E9 Throttle Cable Type Help

    Need the 630 type..... https://www.westmarine.com/sierra-6--630-type-standard-control-cable-for-mariner-40-hp-or-less-pre-1993-with-mariner-mercury-controls-6537054.html?srsltid=AfmBOordhUbdqDnkkUxOiiImUMEjoewWWelzulV6rFBpy70A8il1EV8z56Y
Top