The iboats forum moderators are excited to announce that at this time it appears the iboats forums posting pictures function is working once again. Though we cannot promise for how long, we're hoping for indefinitely.
I bought a thermostat replacement kit for my 89 90 hp evinrude. My ?? is do I need to use any permetex sealant on any of the gaskets provided in the kit? Do I just reassemble and tighten? What about the 2 rubber hoses on the ends. Should i use sealent there too?
pulled the plugs and found very different conditions on plugs. gaps are the same but dont look like proper combustion. any ideas on where to start. carb has been rebuilt and compression is also not the same in the cylinders. 90psi and 140psi. do i have a rebuild project this winter? This is a...
so connect red and purple leads to battery. fuse the purple with what size fuse? It seems that regulator /rectifier is putting out 24v dc will that damage battery?
I have a 2000 rope start, tiller handle model e10r4sse it did not come with electric start. I have measured voltage from a plug that comes out from under flywheel and I get 70v ac at idle and increases when revs up.there yellow wires and from 1 wire to ground its around 30 v and other is 28v and...
motor was running rough after warming up,so pulled plugs and found this. there not the same,is there an issue with the on cyclinder? these are from a 2000 9.9 4 stroke.I have had problems with what seems like a fuel problem( starts to struggle for fuel) pump ball and comes back up but not for long.
I have a 89 90hp evinrude with power tt the motor is making low groaning noises and working intermitenly . no leaks and fluid is ok. I think it might need a motor replacement any help in that process would be great thanks.
89 gls with 90hp evinrude. I need to know if this horn is supposed to "beep" when key is turned to run ---just prior to start, it does alarm when grounding temp sensor, so the horn does work.
great forum,been searching for this answer but cant find one. here is my problem 89 sea nymph boat with 90hp and vro still working, that has 3 wires coming out of it. 2 overheat sensors in the head that has 1 each.I should have a beep with key in run position, prior to start but I don't. I did...
replaceing fuse panel under dashboard of my metal fish boat. factory wireing is in good shape,the add on fish finder, cig liter,marine radio from previous owners all have a fuse at the panel and then an inline fuse also do I need them ? all of these have the same fuse size. the grounding "bus"...
my tracker boat has a trim tilt switch in the throttle lever,up on the side of the hull I need a new one and cant find just the switch. they all com with the whole handle assy. can anyone help me get back on the water?
9.9 drains bulb while i am trolling, I keep priming bulb and runs fine for a couple minutes. I switched bulbs from my 90hp and it drains that one too line are good and fuel screen is clean took cowl off and it runs alot better. any ideas where to start.???????
I put vinyl down on the new wood deck in my boat. the "toe kick ' portion of the deck where it is vertical is metal. the vinyl starts to peel up around the edges,I used the adhesive from nautolex for the floor but on the "toe kick" part used spray adhesive. How can I secure this vertical piece...