Search results

  1. T

    No fuel in carb despite several attempts to crank

    I had similar problems with a 95 Proline and my Sea Ray. Old fuel and debris clogged up Proline fuel pickup, before it could get to water/fuel separator. I had to purchase a cheap automotive 12 volt pump and cycle fuel sever times, after removing pickup tubes' screen, to clean tank. Pulling tank...
  2. T

    Not getting water to crank pumps-Bravo1

    No low water inlets... Attached is a photo of open pump. However, arrows on pump cover show direction to be either way. I didn't attach cover cap photo. We reversed water pressure from pump hose back through transom. No blockage. Pump hoses appear to match body pickup area (2nd photo). Input is...
  3. T

    Not getting water to crank pumps-Bravo1

    I will examine cover. I believe I have it correct. Output water/hose from transom Bravo-itus kit comes from port side of each engine to crank pump.
  4. T

    Not getting water to crank pumps-Bravo1

    all I can see are the vertical small holes on the lower OD.
  5. T

    Not getting water to crank pumps-Bravo1

    Looking at the front of the V8 (crank balancer), the input hose from Bravo kit connects to the lower crank pump connector. The top crank pump hose goes into heat exchanger.
  6. T

    Not getting water to crank pumps-Bravo1

    I just replace both Johnson impellers on both my cranks pumps. I was eating them up. Then, I connected muffs, but no water is getting to pump. Faucet is set on max water output. I disconnected hose at pump head but no water coming out of hose. Both my Bravos had been retrofitted with bravo-itus...
  7. T

    Erratic timing and Vacuum

    I never heard of any vacuum advance on TB4. Learns something new...
  8. T

    MerCruiser 5.7 inboard gas engines not used in years – what to do

    If saltwater used, get ready to spend a bundle of money getting it sea worthy. Replacing motors and cooling....
  9. T

    MerCruiser 5.7 inboard gas engines not used in years – what to do

    all the above and invest in a distributor oil priming tool to get lube throughout motor. Be sure to mark distributor's location prior to using tool.
  10. T

    MC Chevy V8 Bravo 1 Crankshaft water pickup pump issues

    Ordered impellers. Next time I will disconnect hose at pump's body to be sure water is getting up and through intermediate housing and down to pump housing. According to Iboat forum member history, other Bravo 1 users have had similar problems. We never check for water at housing and like you...
  11. T

    MC Chevy V8 Bravo 1 Crankshaft water pickup pump issues

    THX!!!! No strainers. No thru hulls. Water come in via gills/holes on lower OD unit and up through transom assembly and then down to pump. I use a Quicksilver 44357Q2 Through Gear Case Flushing Kit. It is a bit more difficult to attach than clam shell type muffs. But, it also appears to attach...
  12. T

    MC Chevy V8 Bravo 1 Crankshaft water pickup pump issues

    Boat sat in my driveway for about 4 years due to health issues. When I put it up 4 years ago it ran very well. Both motors were about the 150-degree temperature range during sea trial. I am very familiar with Alphas, but it looks like former owner may have skimped on the best water pick up...
  13. T

    Help! Planing issues

    500# I guess I know why "EX."
  14. T

    Help! Planing issues

    I assume Alpa drives? A lot of boat and people for 220 hp. Sounds like boat was never sea trialed? Check for hidden cavities that may have filled with water while prior owner used it. Why did he sell it????? Does top speed fall within parameters for motor? Do you have 2 stroke outboard or 4...
  15. T

    Still issues with base timing TB5 Chevy v8

    Thanks, but Seloc wiring going back to module didn't make any sense, at least to me. Must be some sort of feedback loop in the wiring bundle. Thanks again!!!
  16. T

    Still issues with base timing TB5 Chevy v8

    I know I am supposed to ground the purple/white wire coming out of the DCM for base timing setting but tracing that purple/white wire only goes back to my main wire bundle. Maybe I am not seeing something in the bundle justifying this procedure? Is there a capacitor the wire goes to inside the...
  17. T

    TB5 Chevy 350 Thermostat.

    Thx! I couldn't find any discussion of the best heat range for antifreeze closed cooled systems vs open systems. None of the vendors that I have examined so far differentiate between the heat range of a closed antifreeze system vs closed one. I suspect they were different.
  18. T

    TB5 Chevy 350 Thermostat.

    I have found 143 and 160s locally. I suspect due to being in a warmer environment, I should install a 143. However, are the sea water cooled vs closed cooled stats. different?
  19. T

    Wiring help

    a Sealock manual will provide most wiring color codes
  20. T

    TB5 Chevy 350 Thermostat.

    ???
Top