Search results

  1. Prophammer

    50HP Mercury EFI 4 stroke won't start, have fuel/spark

    What still spins ? The ignition switch ? Does the motor spin over when turning the key?
  2. Prophammer

    9.9 fourstroke gas in the oil

    Thanks for your reply - I'm checking on a new pump now !
  3. Prophammer

    9.9 fourstroke gas in the oil

    (y)
  4. Prophammer

    9.9 fourstroke gas in the oil

    My 2006 mercury 9.9 fourstroke got gas in the oil. Could the fuel pump allow gas to seep into the oil?
  5. Prophammer

    Trim Tab Brackets

    this is reassuring - thanks Scott
  6. Prophammer

    Trim Tab Brackets

    That's a relief ! Thanks
  7. Prophammer

    Trim Tab Brackets

    Trim tab bracket was installed with top bracket pointing down because it would only work that way with decals facing out and for wiring to move through it freely without pinching them- out on the water it works fine like this , should it be redone to point the bracket upward? Or is this just...
  8. Prophammer

    Is this Force 40 Cracked Upper adapter Plate repairable?

    Call Lanier Marine Liquidators in Georgia 770-888-2628 they have gobs of old boats I/O and outboard parts, they might even have a Force laying around
  9. Prophammer

    towing - engine in neutral?

    my son gave me a plastic prop to spin in my receiver hitch - it wouldn't spin after sometime in the weather - I sometimes put my outboard in gear to stop it from spinning - but I don't think it spins much in neutral anyway , when following my wife she was pulling the boat and prop wasn't...
  10. Prophammer

    Have enough HP for hole-shot ?

    Ever need more HP to get out of someone's way ? My co-worker told me he had to do that , he had to do his best hole-shot to avoid collision. He was sitting there in his bass boat when another boat went out of control and headed straight at him, he had enough HP to move fast and get out of the...
  11. Prophammer

    Stringer rotten

    It looks like the floor of a hayloft , but don't give up ! Don't loose heart !
  12. Prophammer

    Odyssey Battery

    Battery that old - I wouldn't trust it - don't shut the SeaDoo off while out on the water, it might not start again. As for Odyssey, they have been around a long time and have a good reputation - sounds good to me !
  13. Prophammer

    BRP Selling many of its marine assets

    I wish they would do their own financing, they could lower the interest rate or go to zero interest , they would sell a lot more , then I could buy a boat instead of paying a bank !
  14. Prophammer

    Can 9.9 Mercury fuel pump leak gas into the oil

    Hey folks I hope everyone is doing well , my 2006 mercury 9.9 got gas in the oil and I wonder if the fuel pump plunger could of leaked gas into the oil that way , any answers , thoughts or comments will be greatly appreciated , Thanks
  15. Prophammer

    2004 Evinrude 115

    Thanks for the reply - I ended up getting a Key West center console with a 115 Yamaha fourstroke - I got scared of the 115 ETec I was looking at!
  16. Prophammer

    2004 Evinrude 115

    I'm thinking about buying a 2004 bowrider with a Evinrude 115 on it. Is the 2004 Evinrude 115 going to give me nightmares riddled with FITCH problems ?
  17. Prophammer

    spin-on gas filter

    dingbat per airshot, very good point , a plastic site glass can be very hard to see thru after a few years of exposure , I'll post another picture of my fuel system when I get it together, Thanks and thanks to all who contributed some of their knowledge
  18. Prophammer

    spin-on gas filter

    I think I'm going to bolt the spin-on filter inside, at the top of the transom board , site glass might be nice - please see pics
  19. Prophammer

    spin-on gas filter

    I was planning on keeping the inline filter under the cowl and add the spin-on filter outside the cowl on the pressure side of the primer bulb. 10 microns spin-on. I never know what will be going on in the boat out on the river, I would like the filter and housing to be all metal in-case it gets...
  20. Prophammer

    spin-on gas filter

    Metal spin on sounds good thanks for letting me know they work good on 8 and 9.9 Roscoe, where I'm going to mount it, It will get just a little back wash over the transom - I will get a metal spin-on , and I'm glad to hear you've done it before, I plan to spin a new one on it every season ...
Top