New owner of a project Chris Craft 30' Tournament Fisherman w/ twin 350's

[Brent Maynard]

Aren't the screws on twin engine boats supposed to turn opposite directions? First project on my boat is replacing port engine, but before pulling it out, they both ran, but in the same direction. Both engines had Paragon tranny's w/ 1:1 ratio, and from what I understand, they didnt make any to run opposite direction. Is it possible these boats were designed to run the screws in the same direction without noticing it pull to one side or the other?

 

[Brent Maynard]

Sorry for sounding like such an idiot in my original post. I finally pulled the numbers from my transmission and did the research, and they were P33-AL/AR. I was originally told that I had direct drive, one direction only tranny's, thus needing one reverse turning engine.