I have a 1996 Yamaha 1100 Waveraider. Rebuilding the carbs and lots of gunk in one of them. I was trying to get the screws out and one of them rounded off. Banging away with a hammer, trying to make a notch on top of the screw and I broke a piece off the body where the fuel inlet cover is. Body is SOL>>> Now I need a new body or buy a used carb I can rebuild.
Anyone out there have a Mikuni that would fit this they would like to part with? It is the middle carb and it is the type with the triangle on top. I believe it is a 38mm but it is hard to accurately find this out online. I have attached a pic if anyone can help. Sure would appreciate this..
Thanks,
B. Holt
Hendersonville, NC 28739
Anyone out there have a Mikuni that would fit this they would like to part with? It is the middle carb and it is the type with the triangle on top. I believe it is a 38mm but it is hard to accurately find this out online. I have attached a pic if anyone can help. Sure would appreciate this..
Thanks,
B. Holt
Hendersonville, NC 28739