Welcome Guest - Sign Up today
Welcome Guest - Sign Up today

Announcement

Collapse

Help Tip: If you have a question that has not been answered to your satisfaction in the archives, it is always best to start a new thread of your own. By starting your own thread, you will receive the maximum number of views by forum members.

Please note this topic has been inactive for 90 days. For the best results, please start a new topic.

Thank you all in advance for doing your part in helping iboats run a smooth ship.

Additional forum rules linked below.
http://forums.iboats.com/forum-rules-guidelines-405/
See more
See less

How do you add fluid to tilt/trim on Yamaha 50hp?

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • How do you add fluid to tilt/trim on Yamaha 50hp?

    I'm assuming that you raise the motor all the way up to relieve pressure and then open the screw and add the fluid. Is this correct? Do you bleed the system by leaving the screw open and lowering the motor?

    Also, is transmission fluid acceptable to use?

    Thanks - Mike

  • #2
    Sign up today
    Re: How do you add fluid to tilt/trim on Yamaha 50hp?

    transmission fluid,dexronIII, is an acceptable subsitute. DO NOT lower that motor with the resevoir plug out. system is self bleeding as per the service manual.
    its also a sealed system that will only require fluid if there is a leak.
    if oil can leak out then water can leak in and the system wont tolerate water long at all.
    no tech questions by PM, they wont get answered.
    you have to be trusted by the people that you lie to .

    Comment

    Working...
    X