Lower unit removal

GILBOMAN2002

Cadet
Joined
May 27, 2015
Messages
12
1989 Suzuki 75 tiller. Trying to change the water pump. Have all the lower unit bolts off. Unit slides down about a quarter inch and then will not lower any further. Is there a pin or a nut somewhere that I have to take off ?
 

WhyNaut

Recruit
Joined
Jun 26, 2019
Messages
4
Sometimes on the shift shaft going to lower unit there is a coupling with a pin in it. It’s typically on front of the leg out side of the leg above the front of cavitation plate.
 

haymon75

Cadet
Joined
Jun 24, 2014
Messages
26
I have a DT65 that is an 89 model and the shift linkage unbolts at the very top under the motor. Look from the left hand side under neath where the control cables connect to the motor.

Hope this helps
 
Top