I have a 1990 Yamaha 200 two stroke. I recently replaced the steering bracket. I had a post for my broken quick connect plug but I wanted to start a new one. Everything was working great up until then. I accidentally ruined the 10 pin harness and decided to hard wire it back together. Long story short I ended up having intermittent electrical issues. When I turned the key on the main gauge would light up like normal. However once I tried to start the motor it would shut off the power to the gauge. I got nothing. As soon as I let the key go the power came back on. I’d have to wiggle the wires around and eventually I’d get it to start. I ended up buying a used engine harness and a brand new harness for the control side. I now had the 10 pin quick connect again. Almost the same issues remain. Power will come on but instead of the power being killed when I turn the key I’ll get one click from the starter area on the motor. Again when I let the key go the power comes back on. Now I trimmed the motor up and when I went to trim it back down it wouldn’t work. When I try to trim up or down I get clicks from the relays. Both batteries are fully charged and were load tested. I removed all battery connections and cleaned them and tightened them all down. All connections on the harness and trim and starter are all right as well. I’m totally lost.