Holy Shamolee
Petty Officer 3rd Class
- Joined
- Jul 18, 2009
- Messages
- 75
I have oil in my bellows.
I am trying to get the part of the top end off that has the u joints connected to it.
There are 4 allen screws.
I managed to strip everyone of them.
I drilled the heads off them.
I think I did an ok job.
I managed to get the 4 washers out.
I have pounded it pretty hard with a rubber mallet.
It will not budge.
Has anyone taken one of these apart?
Does it come apart hard even if you get the screws out properly?
As I look at the schematics, it doesn'look like anything else holding it.
But, I could be wrong.
Does anyone know if there is anything else I have to disconnect
I am trying to get the part of the top end off that has the u joints connected to it.
There are 4 allen screws.
I managed to strip everyone of them.
I drilled the heads off them.
I think I did an ok job.
I managed to get the 4 washers out.
I have pounded it pretty hard with a rubber mallet.
It will not budge.
Has anyone taken one of these apart?
Does it come apart hard even if you get the screws out properly?
As I look at the schematics, it doesn'look like anything else holding it.
But, I could be wrong.
Does anyone know if there is anything else I have to disconnect