I have a VP 5.7 Gxi-C and recently changed my risers on both port and starboard sides after almost 14 years! I went from original VP to Barr risers. When I was finalizing torque (coming up to 28 foot lbs.) on the port side, my Remote Oil Filter Adapter (VP#3860450) cracked on the inboard side mounting tang. I recently purchased a new adapter, but was test fitting it and noticed that the large washer is underneath the outboard side per the installation pictures from Volvo Penta and it doesn't look flush to the riser. Can somebody offer some wisdom on installation of the Remote Oil Filter Adapter? What torque value you recommend? Any tips of advice? Thanks.