xdp drive steering arm removal

[elchiefo]

Hi guys...one of my steering arm or knuckle is worn...not to much place to take the lock nut out on top of the arm...is there a special tool....what is the diameter of that lock nut ...thanks.

 

[elchiefo]

found a nut here and the diameter is 30mm

 

[elchiefo]

hi again ...nobody has done that's job.....thanks

 

[maas]

Hi, we seem to have the same issue with slack in the steering on our xdp drives.

Have you done the repair? I have just started to investigate how to proceed and it would be great with some support from someone who has done the job.

Best regards

Markus from Sweden

 

[GA_Boater]

Hi, we seem to have the same issue with slack in the steering on our xdp drives.

Have you done the repair? I have just started to investigate how to proceed and it would be great with some support from someone who has done the job.

Best regards

Markus from Sweden

The original poster started this thread, asked a few questions and left, not to be seen again. You should start a thread of your own.

Closed.