Ciera2450
Lieutenant Junior Grade
- Joined
- Apr 8, 2011
- Messages
- 1,049
Hi everyone! I am redoing my transom currently and have my drive and shield off for the job. I have known for a while that the shield had a small hole drilled (maybe 1/4”-3/8”)for one of the exhaust relief. Not done by me! Is there any reason I can’t do a proper job and drill the hole properly to match the other side? This would essentially make a v8 shield? Am I missing something else? The hole is obviously supposed to be much larger and the inside edge has a small lip. I can post pics later.
ive owned the boat 7 yrs and ran it this whole time time as is with no issues. Aside from the one little rubber hose breaking off the one side that had the proper factory exhaust relief. Can those hoses be had still? I’ll need two if I’m able to replicate the proper hole.
thanks for any advice!
ive owned the boat 7 yrs and ran it this whole time time as is with no issues. Aside from the one little rubber hose breaking off the one side that had the proper factory exhaust relief. Can those hoses be had still? I’ll need two if I’m able to replicate the proper hole.
thanks for any advice!