Fuel sending unit

[llewis01]

I have a 1994 Albemarle 265. I want to change my float arm sending unit to a tube type. By doing this it will help with better reading and not sloshing in the tank. I'm not sure want type would work with my vdo gauges. Can someone point me in the right direction?

Thanks

 

[alldodge]

If your fuel gauge (also VDO) is like mine it uses the US standard 240-33 ohms (240 full, 33 empty). Now if you The diameter is 54mm (2.1 in), uses an offset 5 hole mounting, and the length is from the top of the tank to the bottom minus a tad.

Here is a length to the tube senders
https://www.vdo-instruments.com/sensors/fuel-level-sender/tube-type.html