Welcome Guest - Sign Up today
Welcome Guest - Sign Up today



Help Tip: If you have a question that has not been answered to your satisfaction in the archives, it is always best to start a new thread of your own. By starting your own thread, you will receive the maximum number of views by forum members.

Please note this topic has been inactive for 90 days. For the best results, please start a new topic.

Thank you all in advance for doing your part in helping iboats run a smooth ship.

Additional forum rules linked below.
See more
See less

Champion 1J212 stator plate

  • Filter
  • Time
  • Show
Clear All
new posts

  • Champion 1J212 stator plate

    I need to change the ignition coil. I removed the stator plate and I can't figure out how to remove the coil from the plate,there doesn't seem to be any screws or bolts holding it to the plate,is there something I'm not seeing? Any advice would be appreciated.

  • #2
    The coil laminations on those Bedix Scintilla magnetos are riveted to the plate. You remove just the coil itself by removing the spring clips on either side of the coil. The plug wire will be soldered to the coil, and will pull through the plate with some wiggling.


    • #3
      Sign up today
      Thanks so much RCO,I'll take a look the minute I get home. I hope the new coils go in easy,but with these old motors nothing's ever easy,but fun to work on.