jbaranski111
Cadet
- Joined
- Apr 4, 2019
- Messages
- 13
I have a 1989 Yamaha Pro 50 tiller and an 1985 Evinrude 9.9. I don't have both motors on my 16 ft boat as it would be too much weight but I swap them out for lakes with a 10hsp restriction.
I share the same tank as I mix 50 to 1. Problem is I have to change the fitting each time on the gas tank. Can I run a female yamaha connector on the end of my evinrude hose at the gas thank(obviously keeping the connector to the evinrude 9.9 omc)?
I share the same tank as I mix 50 to 1. Problem is I have to change the fitting each time on the gas tank. Can I run a female yamaha connector on the end of my evinrude hose at the gas thank(obviously keeping the connector to the evinrude 9.9 omc)?