Welcome Guest - Sign Up today
Welcome Guest - Sign Up today

Announcement

Collapse

Help Tip: If you have a question that has not been answered to your satisfaction in the archives, it is always best to start a new thread of your own. By starting your own thread, you will receive the maximum number of views by forum members.

Please note this topic has been inactive for 90 days. For the best results, please start a new topic.

Thank you all in advance for doing your part in helping iboats run a smooth ship.

Additional forum rules linked below.
http://forums.iboats.com/forum-rules-guidelines-405/
See more
See less

tilt trim guage kit?

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • tilt trim guage kit?

    Hi all, is there a kit available aftermarket or otherwise to add a gauge and sensor for my alpha one gen 2 outdrive? In my opinion it would help take some of the low throttle guesswork out of my lower unit position. This is for my 92 Bayliner 2059. Any ideas? Thanks

  • #2
    Ayuh,.... The odds are the sender is already on the drive, 'n the wires bundled somewhere on the transom,....

    The gauge, 'n a hole to put it in might be all ya need,....

    Comment


    • #3
      I just bought a trim gauge to add to my boat that didn't some with one. I'm interested in how it's wired up. Hope you get some more answers to help both of us out. If I figure it out, I will post here.
      http://forums.iboats.com/forum/boat-...-and-pre-alpha

      Comment


      • #4
        Sign up today
        Sounds good, in the meantime I'm gona check for wires too.

        Comment

        Working...
        X