Not Getting Any Electrical Power to Mercury 150 Saltwater

[DRA2256]

I have a 22 foot 2000 Bayliner Trophy (Model 2052 FD) with a Mercury 150 XL Saltwater engine (serial OT143592). The boat was running great until I stopped to get gas. When I started to cast off, I turned the key and got nothing from the engine - not even a turn over. I tried the remote power trim and it did not move. I tried the button on the side of the motor and it would not move. It sounds like there is a breaker between the battery and the engine is tripped but I can't find it. Can anyone tell me what is wrong or point me to a good electrical system diagram I can use?

 

[carholme]

Re: Not Getting Any Electrical Power to Mercury 150 Saltwater

Your s/n comes up as:

MERCURY - (150 H.P. (2000 ))
Serial No: 0T143592 Model No: 1150462WD

Parts and Service Bulletin List for s/n 0T143592:

Search Results - Crowley Marine

You should have a 20 amp fuse which you can find if you follow the red/purple wire back from the cowl mounted trim switch. Also one of the small red wires from the trim up solenoid should take you back to the fuse.

Gerry

 

[DRA2256]

Re: Not Getting Any Electrical Power to Mercury 150 Saltwater

Your s/n comes up as:

MERCURY - (150 H.P. (2000 ))
Serial No: 0T143592 Model No: 1150462WD

Parts and Service Bulletin List for s/n 0T143592:

Search Results - Crowley Marine

You should have a 20 amp fuse which you can find if you follow the red/purple wire back from the cowl mounted trim switch. Also one of the small red wires from the trim up solenoid should take you back to the fuse.

Gerry

Thanks! I traced it to a bad connection in the fuse connector. The fuse was good but not always making a connection. I appreciate your help.