LakeMeader
Cadet
- Joined
- Jul 24, 2007
- Messages
- 9
Re: Merc 3.0 No power to dash...no 90 amp fuse.
Well Gentlemen I'm quite thrilled to announce that all electrical systems are in full working order however I'm not too thrilled to confess what it was that was causing the problem. After pulling out the dash to check the fuse panel and all the plugs I decided to check that the battery terminals were on tight. Well come to find out that when I replaced the battery one of the ground cables had fallen behind and I only had 1 connected which is why the trim was working.
Please allow me to thank you for your time and wisdom. I have learned a great deal about electrical and that interactive service manual just saved me from renewing my online Seloc manual.
Thanks again!
Todd
Well Gentlemen I'm quite thrilled to announce that all electrical systems are in full working order however I'm not too thrilled to confess what it was that was causing the problem. After pulling out the dash to check the fuse panel and all the plugs I decided to check that the battery terminals were on tight. Well come to find out that when I replaced the battery one of the ground cables had fallen behind and I only had 1 connected which is why the trim was working.
Please allow me to thank you for your time and wisdom. I have learned a great deal about electrical and that interactive service manual just saved me from renewing my online Seloc manual.
Thanks again!
Todd