fishnfool15
Recruit
- Joined
- Sep 2, 2014
- Messages
- 4
Hello fellow iboaters. I have a 1989 Evinrude 110Hp that has been overheating. I pulled the heads to inspect the water deflectors and sure enough they were melted. This was after replacing the thermostats and water pump. My question is do you recommend to mill the heads before reinstalling? What do the pros recommend to clean the surfaces of the head and block before reinstalling? I've seen alot here posted about using sand paper on a glass surface. I'm no professional mechanic, however I would never do that with any heads I pulled of my Chevelle.
Any help is appreciated!
Any help is appreciated!