Welcome Guest - Sign Up today
Welcome Guest - Sign Up today

Announcement

Collapse

Help Tip: If you have a question that has not been answered to your satisfaction in the archives, it is always best to start a new thread of your own. By starting your own thread, you will receive the maximum number of views by forum members.

Please note this topic has been inactive for 90 days. For the best results, please start a new topic.

Thank you all in advance for doing your part in helping iboats run a smooth ship.

Additional forum rules linked below.
http://forums.iboats.com/forum-rules-guidelines-405/
See more
See less

1973 85 hp evinrude wiring

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • 1973 85 hp evinrude wiring

    I have a 1973 evinrude 85 hp. When I got it, someone had rigged the wiring, to a new ignition switch. I have no idea what wires are which. The engine will not cut off with the switch. I have to use the kill switch to turn off the engine. I purchased a manual, but the wiring diagram is vague. It only covers all 1973 v4 motors. Can anyone help me make heads or tails of the wires to hook this up correctly?

    Thanks ahead of time!!

  • #2
    Re: 1973 85 hp evinrude wiring

    A typical push to choke switch is wired as shown here: http://www.maxrules.com/graphics/omc...REMCONTBOX.jpg

    The original switch for your motor was wired as shown in the thumbnail.
    Attached Files

    Comment


    • #3
      Sign up today
      Re: 1973 85 hp evinrude wiring

      Thanks for your help

      Comment

      Working...
      X