GilligansIsland
Petty Officer 2nd Class
- Joined
- Apr 14, 2010
- Messages
- 138
I've been checking the boards out for a while and hope someone can help...
I just picked up an '86 Evinrude 2hp and I need to change the impeller.
I've got the lower off and have taken out the two screws that seem to hold down the housing for the impeller, but it's stubborn and I'm afraid to force it and break it.
What is the best way to get this housing off? Is is normally installed with a sealant of some type?
Also, are there any good service manuals out there for it? I bought a Seloc that covers a wide range of years but it's just too general.
...thanks in advance for the help
.
I just picked up an '86 Evinrude 2hp and I need to change the impeller.
I've got the lower off and have taken out the two screws that seem to hold down the housing for the impeller, but it's stubborn and I'm afraid to force it and break it.
What is the best way to get this housing off? Is is normally installed with a sealant of some type?
Also, are there any good service manuals out there for it? I bought a Seloc that covers a wide range of years but it's just too general.
...thanks in advance for the help
.