1983 75 HP Evinrude Model# E75TRLCTE<br />Motor was bogging at WOT. Checked for spark by removing lead while running. No change in idle on #1, motor almost stalls when removing #2 or #3. New plugs, no change. Changed wires, still no fire #1. Swapped ignition coils along with wiring to power pack. No change. Changed power pack, still not firing. Checked for spark by removing plug and holding with pliers while someone starts motor, no spark. Tried spraying premix into carb on #1, no change. #1 plug is wet with fuel when removed. <br /><br />Compression is good.<br /><br />One strange occurance. After swapping the powerpack with a new one, the motor would not even start. It would turn over but not start. I then tested the #1 plug wire and it was bad, it must of broke from being removed so often. When I put a new one on, the motor started right up but still no fire on #1. Strange??